System Requirements; Board Setup; Table 2. X-Nucleo-Pgeez1 Jumper Settings - STMicroelectronics X-NUCLEO-PGEEZ1 User Manual

The EEPROM communicates with the
signals available on the Arduino® UNO R3 connector.
The X-NUCLEO-PGEEZ1
complete testing has been performed using the NUCLEO-F401RE, NUCLEO-L053R8, NUCLEO-G474RE, and
NUCLEO-H743ZI
2.4

System requirements

To use the STM32 Nucleo
• a Windows PC/laptop (Windows 7 or above) to install the firmware package (X-CUBE-EEPRMA1)
• a type A to Mini-B USB cable to connect the
• an STM32 Nucleo
NUCLEO-H743ZI)
• an X-NUCLEO-PGEEZ1
2.5

Board setup

Follow the table below for the correct jumper settings.
Jumper Name
J09 M95_MOSI
J10 M95_MISO
J11 M95_WPn
J12 M95_Hn
J13 U1_CS
J15 M95_SCLK
J17 M95_VDD
J19 USR_VDD
UM3096 - Rev 1
STM32 Nucleo
has been designed to be used on any
development boards.
development boards with the
development board (NUCLEO-F401RE, NUCLEO-L053R8,
expansion board
Table 2. X-NUCLEO-PGEEZ1 jumper settings
Configuration (for STM32 Nucleo-144 board)
2-3
2-3
2-3
2-3
2-3
2-3
2-3
1-2
development board host microcontroller through the SPI
STM32 Nucleo
X-NUCLEO-PGEEZ1 expansion board, you need:
STM32 Nucleo development board to the PC
Configuration (for STM32 Nucleo-64 board)
UM3096
System requirements
development board, although
NUCLEO-G474RE or
1-2
1-2
1-2
1-2
1-2
1-2
2-3
1-2
page 4/27