Before you begin Be sure to read through the manual and familiarise yourself with the instructions Visualise a plan to assemble all the pieces Make sure you have all of the hardware and tools Be sure to have enough instant glue Dry fit all parts before painting and assembling Tip: It will help to paint all of the parts before final assembly ahead RC...
Page 4
Combining and assembling the split cab Repeat on the other side M3x10mm CS M3x15mm BH Repeat on the 3mm other side orange LED x6 M3 lock nut x12 M3 lock nut x12 Repeat on the other side ahead RC...
Page 5
M3 lock nut x12 M2x10mm OPTIONAL: Either hard mount with glue or use your own hinges ahead RC...
Page 6
Mounting the fenders M3x10mm If using wide track fenders: Use M3x15mm x18 ahead RC...
Page 7
Assembling the rear of the cab Repeat on the other side 5mm White LED x2 M2x10mm 5mm 5mm Red LED x2 Orange LED x2 Repeat for all 6 lenses ahead RC...
Page 13
M2x10mm Repeat on the other side ahead RC...
Page 14
Close gate M2x10mm Repeat on the other side Repeat for 12 side window hinges Repeat for all 6 lenses Repeat for all 8 cab side hinges ahead RC...
Page 15
Repeat for 3 rear window hinges ahead RC...
Page 16
Mounting the front panel of the cab M3x10mm x11 CS ahead RC...
Page 17
Body is now fully complete. Thank you for selecting ahead RC products. If you have any questions or need help with the assembly, please do not hesitate to contact us at: aheadrc@gmail.com or visit us at: www.aheadrc.com Best of luck with your build! ahead RC...
Need help?
Do you have a question about the Crawler Cat 1 and is the answer not in the manual?
Questions and answers