Panasonic NU-MX100P Operating Instructions Manual page 5

*Data prepared by Panasonic with test conditions - ambient
temperature 25℃, three 250 ml wide-neck bottles and nipples,
three 250 ml narrow-neck bottles and nipples, and indicated
water volume in chart.
There is still residual heat on the sterilized
items when the product just finishes the work.
Pay attention to the residual heat before use.
Drying Function
(1) Place the body on the base, put the baby bottles, teats
and other small items to be dried in the body of the
product, and cover it with the lid.
(2) Turn on the power supply, press the Power Pad "
(3) Press the Drying Pad "
press the Pads "
of 40, 60 or 80 minutes.
*The default setting time for drying is 40 minutes.
(4) If there is no further operation in 3 seconds, it will enter
working state after a "Beep" Sound.
(5) The product will beep 3 times and the indicator will flash
after the program.
Sterilization/Drying Function
(1) Measure 90 ml water with the measuring cup (maximum
200 ml) and pour it into the water storage tank of the base.
(2) Place the body on the base, put the baby bottles, teats
and other small items to be sterilized/dried in the body
of the product, and cover it with the lid.
(3) Turn on the power supply, press the Power Pad "
(4) Press the Sterilizing/Drying Pad "
program, and press the Pads "
the desired drying time of 40, 60 or 80 minutes.
*The default setting time for drying is 40 minutes.
(5) The product will start the sterilization mode after
3 seconds without further operation and a "Beep" sound.
After the water is dried up and the sterilization finishes,
the product will automatically enter the drying mode and
continue to work.
(6) The product will beep 3 times and the indicator will flash
after the program.
Note:
① The water storage tank of the base can hold water
up to 200 ml. It is recommended that at least 90 ml
of water should be added. The more water is added,
the longer the working time will be. The product
can sterilize for about 20 minutes at most or until it
automatically enters the drying mode.
② The default drying time is 40 minutes, you can select
the above-mentioned time according to your needs.
There is still residual heat on the sterilized
items when the product just finishes the work.
Pay attention to the residual heat before use.
" to enter this program, and
" and " " to select the desired time
Eng-4
" to enter this
" and " " to select
" .
" .