Install Switch/Connect Other Devices - NETGEAR ProSafe GS105 Installation Manual

3 Install the Switch and Connect the
3
Other Devices
Apple G4
GS105
10/100/1000 Mbps Gigabit Switch
On=10M, Blink=ACT
1 2 3 4 5
Power Green=FDX, Yellow=COL 1
GS105 5-Port 10/100/1000 Mbps
Gigabit Ethernet Switch
1. Place the switch on a flat surface or hook onto the screws.
2. For each device, insert one end of an Ethernet cable into the port in the device and insert
the other end into one of the Ethernet ports on the switch.
3. Connect the power adapter's cord into the back of the switch and then plug the adapter
into a power source (such as a wall socket or power strip).
The Power light
should light up.
The corresponding
Link LED for each
connected and
powered device
should light and flash when activity occurs. If the connection is 1,000 Mbps or 100
Mbps, the LED in the RJ-45 jack will light up. If the connection is 10 Mbps, the 10M
LED on the left side of the front panel will light up.
Note: If any light doesn't operate as indicated, go to the Troubleshooting section.
PC with
GA302T
Adapter
Gigabit Gigabit
Ethernet
1000M 100M
Auto
Uplink
2 3 4 5
Power ACT, FDX, COL LED
10/100/1000 Mbps Gigabit Switch
On=10M, Blink=ACT
1 2 3 4 5
Power Green=FDX, Yellow=COL
Model GS105 5-Port 10/100/1000 Mbps Gigabit Ethernet Switch
Server with GA622T
Adapter
LOCAL
10/100M
8 7 6 5 4 3 2 1
FVS318 ProSafe VPN Firewall
1000M
LED
Gigabit Gigabit
GS105
Ethernet
1 2 3 4
DSL
modem
INTERNET
12VDC 1.2A
OFF ON
100M
LED
1000M 100M
Auto
Uplink
5