Zoom - Canon EOS C300 Mark III Manual

Zoom

Zoom
In CAMERA mode, you can use the camera to zoom when an EF Cinema/broadcast lens compatible with zoom
operation (A 237) or an EF lens integrated with an optional PZ-E1 Power Zoom Adapter is attached to the
90
camera.
You can also zoom remotely using Browser Remote on a connected network device (A 181, 183).
Required settings on EF Cinema lenses and broadcast lenses
To operate the zoom from the camera, you will need to enable automatic adjustment using the controls on the
lens. Required settings vary depending on the lens. Refer to the following table and the instruction manual of the
lens used.
Lens (A 237)
CN7x17 KAS S/E1, CN10x25 IAS S/E1,
CN20x50 IAS H/E1
CN-E18-80mm T4.4 L IS KAS S,
CN-E70-200mm T4.4 L IS KAS S
EF-S 18-135mm F3.5-5.6 IS USM*
* When using the optional PZ-E1 Power Zoom Adapter, make the required setting on the PZ-E1, not the lens.
1 Enable automatic zoom adjustment on the lens.
2 Select > [
3 Select > [
• Zoom speeds are constant; [1] being the slowest and [16] the fastest.
4 After closing the menu, use the joystick on the camera grip to zoom.
• Push the joystick up to zoom in (telephoto) and push it down to zoom out (wide-angle).
NOTES NOTES
• When an optional RC-V100 Remote Controller is connected to the camera and the lens is correctly set, you
can zoom with the remote controller's ZOOM dial.
• When using slow zoom speeds, it may take longer for the lens to start moving.
Part used on the lens
Zoom operation change-over knob
Zoom change-over switch
Zoom mode switch
v
Camera Setup] > [Camera Grip Zoom] > [On].
v Camera Setup] > [Camera Grip Zoom Speed] > Desired zoom speed.
Setting for automatic adjustment
SERVO
SERVO
PZ (Power Zoom)