Gigabit Module Bay - NETGEAR ProSafe FSM7328PS Hardware Installation Manual

Managed Stackable Layer 3 Fast Ethernet Switches Hardware Installation Guide

Gigabit Module Bay

You can install an SFP Gigabit Ethernet module in the gigabit module bays. SFP
modules are sold separately.
Four ports on the switch can be used for either STP (RJ-45) or SFP (fiber) cable.
However, both port types cannot be used at the same time. The switch selects the
first connected interface. If both connectors are plugged, the SFP interface
operates normally and disables the copper interface.
The SFP bay accommodates a standard SFP module with an LC connector that is
compatible with the IEEE 802.3z 1000BASE-SX standard.
To install an SFP module:
1. Insert the SFP module into the SFP module bay. Press firmly to ensure that the
2.
Connecting a Console to the Switch
After you install the switch and apply power, you can connect to it with a terminal
or workstation. You can use the Command Line Interface (CLI) to identify the IP
address. If you are stacking switches, see "Stacking Switches " on page 3-7.
To use a console ,you need:
•
•
To connect a console to the switch:
1. Connect the null-modem cable to the console port of the switch.
Hardware Installation
module seats into the connector.
To install additional modules, repeat step 1.
VT100/ANSI terminal; or a Windows PC, Apple Macintosh, or UNIX
workstation.
Null-modem cable with 9-pin connectors on each end (shipped with the
product)
Figure 3-4
Console port on front panel
v1.0, May 2007
3-9