NETGEAR ProSafe FSM7328PS Hardware Installation Manual page 19

Managed Stackable Layer 3 Fast Ethernet Switches Hardware Installation Guide
•
•
•
•
•
•
•
•
•
•
•
Introduction
Keep your system away from radiators and heat sources. Also, do not block
cooling vents.
Do not spill food or liquids on your system components, and never operate the
product in a wet environment. If the system gets wet, see the appropriate
section in your troubleshooting guide or contact your trained service provider.
Do not push any objects into the openings of your system. Doing so can cause
fire or electric shock by shorting out interior components.
Use the product only with approved equipment.
Allow the product to cool before removing covers or touching internal
components.
Operate the product only from the type of external power source indicated on
the electrical ratings label. If you are not sure of the type of power source
required, consult your service provider or local power company.
To help avoid damaging your system, be sure that the voltage selection switch
(if provided) on the power supply is set to match the power available at your
location:
– 115 volts (V), 60 hertz (Hz) in most of North and South America and in
some Far Eastern countries such as South Korea and Taiwan
– 100 V, 50 Hz in eastern Japan and 100 V, 60 Hz in western Japan
– 230 V, 50 Hz in most of Europe, the Middle East, and the Far East
Also, be sure that attached devices are electrically rated to operate with the
power available in your location.
Use only approved power cables. If you have not been provided with a power
cable for your system or for any AC powered option intended for your system,
purchase a power cable that is approved for use in your country. The power
cable must be rated for the product and for the voltage and current marked on
the product's electrical ratings label. The voltage and current rating of the
cable should be greater than the ratings marked on the product.
To help prevent electric shock, plug the system and peripheral power cables
into properly grounded electrical outlets.
The peripheral power cables are equipped with three-prong plugs to help
ensure proper grounding. Do not use adapter plugs or remove the grounding
prong from a cable. If you must use an extension cable, use a three-wire cable
with properly grounded plugs.
v1.0, May 2007
2-11