Asus Aaeon de next-TGU8 User Manual page 77

Options Summary
Selects serial port transmission speed. The speed must be matched on the other side.
Long or noisy lines may require lower speeds.
Data Bits
Data Bits
Parity
A parity bit can be sent with the data bits to detect some transmission errors.
Even: parity bit is 0 if the num of 1's in the data bits is even.
Odd: parity bit is 0 if num of 1's in the data bits is odd.
Mark: parity bit is always 1.
Space: Parity bit is always 0.
Mark and Space Parity do not allow for error detection. They can be used as an
additional data bit
Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates the beginning).
The standard setting is 1 stop bit. Communication with slow devices may require more
than 1 stop bit.
Flow Control
Flow control can prevent data loss from buffer overflow. When sending data, if the
receiving buffers are full, a 'stop' signal can be sent to stop the data flow. Once the
buffers are empty, a 'start' signal can be sent to re-start the flow. Hardware flow control
uses two wires to send start/stop signals.
VT-UTF8 Combo
Key Support
Enable VT-UTF8 Combination Key Support for ANSI/VT100 terminals
Recorder Mode
On this mode enabled only text will be sent. This is to capture Terminal data.
Resolution 100x31
Enables or disables extended terminal resolution
Chapter 3 – AMI BIOS Setup
38400
57600
115200
7
8
None
Even
Odd
Mark
Space
1
2
None
Hardware RTS/CTS
Disabled
Enabled
Disabled
Enabled
Disabled
Enabled
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
64