Table of Contents
Advertisement
Prepare the Site
Before you begin installing your switch, prepare the installation site. Make sure
your operating environment meets the operating environment requirements of
the equipment.
Characteristic
Temperature
Operating humidity
Ventilation
Operating conditions
Power
Install the Switch
To install your switch on a flat surface, you do not need any special tools. Be
sure the switch is positioned with at least 2 inches of space on all sides for
ventilation.
To install the switch on a wall, measure the distance between the mounting holes
on the back of the switch and mark the wall to match the location of the
mounting holes on the switch. At the marked location, screw into the wall the
two screws that you received with the mounting kit included in your package
contents. Be sure to choose a location that is near the devices to be connected, is
close to an electrical outlet, and provides at least 2 inches of space all around the
switch for ventilation.
Model FS308 Fast Ethernet Switch Installation Guide
Requirement
Ambient temperature between 0 and 40 C (32 and 104 F).
No nearby heat sources such as direct sunlight, warm air
exhausts, or heaters.
Maximum relative humidity of 90%, noncondensing.
Minimum 2 inches (5.08 cm) on all sides for cooling.
Adequate airflow in room or wiring closet.
At least 6 feet (1.83 m) to nearest source of electromagnetic
noise (such as photocopy machine or arc welder).
Adequate power source within 6 feet (1.83 m).
Advertisement
Table of Contents
