Product Illustration; Front Panel; Vista Rj-45 Network Ports With Built-In Leds - NETGEAR FS308 Installation Manual

Product Illustration

8
PORT
Fast Ethernet Switch
10/100Mbps

Front Panel

The front panel of the Model FS308 switch contains the following LEDs that
correspond to each network port located on the back of the hub: 100 Mbps link/
activity (100 Link/Act), 10 Mbps link/activity (10 Link/Act), and full-duplex/
collision (FDX/Col). Each vista RJ-45 network port has its own 100 Link/Act
and 10 Link/Act LED as well.
LEDs
The table below describes the activity of the LEDs.
Label Color
Pwr (Power) Green
100 Link/Act Green
10 Link/Act Green
FDX/Col Green
Yellow

Vista RJ-45 Network Ports with Built-in LEDs

All of the ports on the switch are 10/100 Mbps capable autosensing Ethernet
ports. Each port supports only unshielded twisted pair (UTP) cable using an 8-
pin RJ-45 plug. Each port uses vista RJ-45 connectors that have two LEDs—the
100 Link/Act LED and the 10 Link/Act LED.
Model FS308 Fast Ethernet Switch Installation Guide
Power LED
Auto 10/100 Mbps
100 Link/Act.
10 Link/Act.
FDX/Col.
Power
1 2
Activity Description
On Power is supplied to the switch.
Off Power is disconnected.
On The port is operating in 100 Mbps mode.
Data is being received or transmitted at 100
Blinking Mbps.
On The port is operating in 10 Mbps mode.
Data is being received or transmitted at 10 Mbps.
Blinking
On The port is operating in full-duplex mode.
A collision is occurring on the segment when the
Blinking port is operating in half-duplex mode. (Note that
some collisions are normal.)
100 Link/Act 10 Link/Act
100 Link/Act
LEDs
MODEL FS308
3 4 5 6 7 8
FDX/Col 10 Link/Act
LEDs LEDs
8921FA
8923EA