Advertisement
3.
ASSEMBLY
3.1
The bench should be built upside down. Do not turn the right
way up until all bolts have been fully tightened. Generally
speaking the bolt heads should be on the externally visible
sufaces with the nuts and washers hidden out of sight.
3.2
Lay one of the legs on the floor and place the shelf onto it as
shown in fig.2-A . The shelf must be supported until both bolts
are in place. The turned down lip at the front of the shelf
should be nearest to the foot. Place a bolt into the hole
nearest to the foot and hand tighten the nut down onto a
washer. Continue to support the shelf. Turn it through 90
degrees so that you can bolt the same leg to the side of the
shelf. Only hand tighten at this stage.
3.3
Now attach a second leg to the shelf using two sets of fixings as
shown fig.2-B.
3.4
Put some protective material onto the floor and place the
bench top face down on top of it. Refer to fig.3. Attach the
remaining two legs to the back edge of the upturned bench
using the nuts, bolts and washers provided, as shown in fig.3-A.
3.5
Now lift the shelf with the legs attached and stand it on to the
upturned bench top so that the legs go between the inner
edge of the bench and the supports and the back edge of the
shelf rests inside the legs already attached to the bench as
shown in fig.3. Ensure that you have adequate help to do this.
3.6
Attach the back edge of the shelf to the rear legs using two
sets of fixings on each leg. These fixings go in the holes
furthest away from the feet. ( See fig.3-B.)
3.7
Now bolt the front legs to the cross members on the underside
of the bench top. The legs should be on the outside faces of
the cross members as indicated on fig.3-C. All fixings should be
hand tight at this stage.
3.8
Check that the assembly is correct and then tighten all bolts with a 17mm spanner before the bench is turned upright.
3.9
Ensure that you have enough help to turn the bench upright and lift it into its final position. Support the bench whilst gently tipping it onto its rear
face. Now roll the bench onto its four feet taking care not to let the feet slide as you turn the bench fully upright.
4.0
To assemble the barrel lock to the draw ( see fig.1-A ), hook the the locking arm through the draw front making sure that the lock is rotated so the
flats on the barrel line up with the flats in the hole and the lock is the right way up so that the arm turns upwards into the locking position. Refer to
fig.1. To fix the lock in place press firmly on the front of the lock until the two sprung teeth on the barrel pass through the hole and come to bear
on the inside face of the draw.
4.1
Slide the draw unit half way into the sheet metal runners on the underside of the bench top ( see fig.1-B ). Take the bent sheet metal draw stop
component ( see fig.1-C ) and bolt it to the back of the draw in the orientation shown in the drawing. The draw stop will then come to rest on the
back of the bench front edge thus preventing the draw falling out when it is fully opened.
Sole UK Distributor, Sealey Group,
Bury St. Edmunds, Suffolk.
01284 703534
01284 757500
fig. 2
fig. 3
E-mail: sales@sealey.co.uk
AP1010, AP1015, AP1020 - 2 - 110402
Advertisement
