Menda 35851 Operation And Maintenance Manual

Mega Vac Commercial Vacuum
Operation and Maintenance
Figure 1: The Mega Vac, Item 35851

Description

The Menda 35851 Mega Vac is a high capacity, high
performance, service vacuum. This model has been
specifically designed with large clean-up jobs in mind.
The powerful by-pass motor can handle almost any job.
It was designed for those technicians who require a
large, mobile vacuum for use in and around sensitive
electronic equipment such as copy centers, telecom
centers, rechargers, garages, refiners, shops, and
schools. The standard 0.3 micron filter canister is ideal
for dust, glass, pollens, soot, drywall dust, brake dust,
toner, and other fine particles. The optional .12 micron
HEPA filter canister is suitable for lead and other ultra-
fine particles. The filters are fully contained for safe,
easy disposal.
The Mega Vac is safe for ESD susceptible electronics.
The 10' long hose and the utensils are static dissipative.
The internal ground-wire in the flex-hose and enclosure,
virtually eliminate static charge generation from the
utensils. Any charge generated is safely dissipated
back through the electrically grounded motor.
Note: The Menda Mega Vac is designed for commercial
use only.

Inspection:

Remove the Mega Vac from the shipping carton and
inspect for exterior damage.
TB-4004 9/01 Page 1 of 2
TECHNICAL BULLETIN TB-4004
3651 Walnut Avenue, Chino, CA 91710
Phone: (909) 627-2453 • Fax (909) 755-8848 • Web Site: www.mendapump.com

Items included with model 35851:

1 0.3 Micron 5 Gallon Filter Canister
1 10' Flex-Hose (Toner Proof and Static Dissipative)
1 Goose Neck Attachment
1 Crevice Attachment
1 Crevice Attachment Brush
1 Detachable Power Cord (110V Only)
1 Base With Easy Rollers
1 Foot Switch
Figure 2: Items included with Model 35851

Optional Accessories

35858 Replacement 0.3 Micron Filter Canister
35859 Replacement .12 Micron HEPA Filter Canister

Operation

Place the vacuum head
onto the filter canister by
inserting the white down
tube into the correspond-
ing size hole in the filter
canister (fig. 3). Align the
rubber retaining clips with
the corresponding chrome
retainer latches on the
vacuum head and stretch
into place (fig. 4). Place
the head and canister into
the mobile base. Insert
either end of the flex hose
into the knurled aluminum
recepticle on the top of the
vacuum head (fig. 5).
Made in America
Figure 3: Aligning down
tube