Advertisement
Available languages
Available languages
5.
6.
BEFORE GRINDING
Note: The machine can be operated only when it is grounded well.
The machine can be started only when safety is ensured
Other objects or human body should not touch the grinding wheel to avoid accidents
Cleaning
1. Make sure to keep the surface of your unit free of grit, dirt, and grease. Use soapy water or
nontoxic solvents. Do not use petroleum based solvents.
2. Keep the air vents free of foreign matter at all times.
Pull out 40#(the Hold Accessory )and erecting it in 34#(Stand
Socket); CAREFUL make sure that the heave on 35# (Positioner
for Blade) inserts in the groove on 34# (Stand Sockets) , move
the Positioner for Blade from side by side, begin to sharpen.
(See Figure 6)
Where there is no grinding sound between the grinding wheel
and the drill, pull out 35# Accessory and turn it by 180°, and
then conduct grinding; the procedure is as same above
(Figure 6)
mentioned.
Place 35# Accessory on the 14# Spacer, facing back angle
of the drill, and turn 35# Accessory to the left and to the
right; conduct grinding. On condition that no grinding sound
between the grinding wheel and the drill, pull out 35#
Accessory and turn it by 180°, and then conduct grinding;
the procedure is same as above mentioned; the operation is
finished. (See Figure 7)
AFTER GRINDING
6
Advertisement
