Advertisement
Available languages
Available languages
when working. Wear restrictive hair covering to contain long hair.
8. USE EYE AND EAR PROTECTION. Always wear ANSI approved chemical splash goggles
when working with chemicals. Always wear ANSI approved impact safety goggles at other
times. Wear a full face shield if you are producing metal filings or wood chips. Wear an ANSI
approved dust mark or respirator when working around metal, wood, and chemical dusts and
mists.
9. DO NOT ABUSE THE POWER CORD. Do not yank it to disconnect it from the receptacle.
Do not carry tools by the cord.
10. DO NOT OVERREACH. Keep proper footing and balance at all times. Do not reach over or
across running machines.
11. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and changing accessories. Inspect tool cords
periodically and, if damaged, have them repaired by an authorized technician. The handles
must be kept clean, dry, and free from oil and grease at all times.
12. DISCONNECT POWER. Unplug when not in use, before servicing, and when changing
accessories.
13. REMOVE ADJUSTING KEYS AND WRENCHES. Make it a habit to check that keys and
adjusting wrenches are removed from the tool or machine work surface before plugging it in.
14. AVOID UNINTENTIONAL STARTING. Be sure the switch is in the OFF position when not
in use and before plugging in. Do not carry any tool with your finger on the trigger, whether it
is plugged in or not.
15. OUTDOOR EXTENSIONS CORDS. When the equipment is operated outdoors, use only
extension cords intended or outside use. See chart under'Extension Cords': For the proper
AWG rating depending on the length of the cord(s) being used.
16. STAY ALERT. Watch what you are doing, use common sense. Do not operate any tool when
you are tired.
17. CHECK DAMAGED PARTS. Before using any tools, any part that appears damaged should
be carefully checked to determine that it will operate properly and perform its intended
function. Check for alignment and binding of moving parts; any broken parts or mounting
fixtures; and any other condition that may affect proper operation. Any part that is damaged
should be properly repaired or replaced by a qualified technician. Do not use the tool if any
switch dose not turn on and off properly.
18. GUARD AGAINST CLECTRIC SHOCK. Prevent body contact with grounded surfaces such
as pipes, radiators, and refrigerator enclosures.
19. REPLACEMENT PARTS AND ACCESSORIES. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use accessories
intended for use with this tool.
20. DO NOT OPERATE TOOL IF UNDER THE INFLUENCE OF ALCOHOL OR DRUGS.
Read warning labels on prescriptions to determine if your judgment or reflexes are impaired
while taking drugs. If there is any doubt, do not operate the tool.
21. KEEP AWAY FROM LIQUIDS. Tool is designed for dry sharpening operations only.
22. BE CAREFUL OF BITS WHEN SHARPENING. Bits will become hot. Be careful when
handling; allow tips to cool for some time before storing.
23. SHARPENING HEAD MAY BECOME HOT WHILE USING. This is a normal condition and
4
Advertisement
