Software Configuration - NetComm V110 Quick Start Manual

SOftWArE CONfIGurAtION

Easy Setup utility (for Windows Only)
1. For easy configuration, insert the included CD into your CD-ROM drive. The CD should auto-start. If it
does not start, click on Start -> Run and type in D:\Easysetup\vbpES.exe (where D is the drive letter of
your CD-ROM drive).
2. The default Internet access is DHCP Client Mode. Click on WAN Configuration to change the internet
access type.
3. Enter the SIP Proxy Domain, Proxy Server, Outbound Proxy, Username, Auth. ID and Auth. Password
provided by your VSP.
4. And then click on Setup, the software will start to configure the NetComm ATA. Follow the instructions of
the Easy Setup utility which will guide you to complete the configuration.
5. After a few minutes, the NetComm ATA should report that the setup has been successful.
Note: The easy setup utility can not be used to retrieve details. The utility will initialize the unit back to default settings when executed.
YML882Rev1
www.netcomm.com.au
�11��� �21���� �211�� �22� Quick Start Guide �11��� �21���� �211�� �22�