PROakcess PROenerg 100 Manual page 4

Battery charger 6V - 12V
PROenerg 100 is a conventional battery charger suitable for charging small to medium sized
batteries from 20 to 150Ah. Suitable for lead, AGM, gel batteries. The modular charging voltage in
6 or 12V also allows you to recharge your motorcycle batteries.
Specifications
Input current: 230V - 50Hz
Output current: DC 6V / 12V
Max load 5A(6V) / 8A(12V)
Capacity of the batteries to be charged: 20 to 150 AH
Safety Precautions
- This appliance is not intended for use by young children or persons who cannot read or
understand the manual, except under the supervision of a responsible person who ensures
that they can use the battery charger safely. Store and use this charger out of the reach of
children and make sure they cannot play with it.
- Check that the battery to be charged is properly rechargeable, that its voltage is 6V or 12V,
and that the battery is not damaged. The terminals must be clean and dry before connection.
- Not suitable for recharging Lithium battery.
- During charging, the battery produces explosive gases. Keep away from any source of flame
or sparks during use. Always use in a cool, ventilated area. Do not smoke in the vicinity!
- Do not use inside the car or under the hood, do not cover, do not use in rain, snow, or
sunlight.
- Always wear suitable gloves (rubber if possible) and goggles when working on the battery
which contains corrosive acid.
- Do not use your unit if the clamps, the battery to be charged, or the cable jackets are
damaged. If the product fails, it can only be repaired by a specialized technician, contact
info@proakcess.com.
- Never put the clamps in contact with each other, nor connect them to the same metal object
(risk of short circuit).
PROenerg 100 is equipped with a circuit breaker. In the event of overcurrent or overheating, the
circuit breaker will go to the off position, normal current or temperature conditions must be
restored and the circuit breaker returned to the on position.
If the polarity is reversed, the fuse will melt and must be replaced. A replacement fuse is delivered
with your product.
Operating mode: CHARGING
1- check the battery to be charged.
It must be clean, dry and undamaged.
! Read the manual before any use !