Raider RD-ST01 User Manual page 14

14 www.raider.bg
arise for the user through the use of other spare parts. The manufacturer is not liable for any damage
or injury resulting from such action.
4 DESCRIPTION (FIG. 1)
1. Main plug
2. Lock off button
3. Switch trigger
4. Handle
5. Front handle
6. Guide bar lower section
7. Discharge chute
8. Auger
9. Motor housing
5 ASSEMBLING
Guide bar (Fig. 1)
Slide the lower section into the upper tube.
Line up holes on each tube, and make sure that the internal cable (A) does not pass the mounting
holes.
Fix two sections firmly with the supplied screw and swing nut.
Motor housing (Fig. 1)
Connect socket (B) to the plug on the motor housing.
Fasten the housing by supplied 4 screws.
Front handle
Loosen the knob and lift up the handle bar to the operation position. (Fig. 2)
Adjust the height of the handle to a safe and comfortable position and fix it by the knob.
Connection the mains cable (Fig. 3)
Loop the extension cord and feed it through the rear handle. Rest the cord around the cord hook.
This will help prevent you from disconnecting the extension cord from the product during operation.
Warning! Do not handle the plug or the appliance with wet hands or while standing in water.
DANGER! Electric shock causes series injury and death!
6 STARTING
Intend use
This appliance is only intended for sweeping of snow on steps, patios and decks in private domestic
and hobby gardens.
It is not designed for use in public areas, parks, sports areas, and in agriculture and forestry. Using
the application only on hard, flat surfaces free of sad, stone and debris, wires and any other objects.
For any other purpose is considered incorrect and unapproved. The manufacturer is not liable for any
damage or injury resulting from such use. The user is entirely responsible for any associated risks.
On/Off switch (Fig. 4)
Warning! The auger starts rotation immediately after switch on! Keep hands and feet away
from auger.
To switch on, hold the appliance firmly with two hands and press the safety lock off button while press
the On/Off switch trigger. Keep the switch trigger hold while release the button. To stop the appliance,
release the switch trigger and it automatically returns to its start position.
7 REMOVING SNOW
• Before starting work, make sure that the area to be clear is free of stones, debris, wires and any
other objects.
• Make sure all fasteners (screws, nuts, etc.) are always fully tightened so that you can work safely
with the appliance.
• Check the auger for wear and tear at regular intervals.
• Position discharge chute in safe direction and angle, away from operator and bystanders.