Lighting Main Burners; Lighting Side Burners - Coleman 8450 Series Assembly Manual

Lighting Main Burners

1. Push and turn one of the three left main burner control knobs counterclockwise to the
"HIGH" position. Wait 5 seconds. (Fig. 23, 24, and 25)
2. Press and hold the left electronic igniter button. You will hear a snapping sound. (Fig. 25)
3. If the burner does not light in 4 seconds, turn the control knob to OFF and wait 5 minutes for
the gas to clear before trying again.
4. Repeat steps 1 through 3 to light the remaining burners.
NOTE: The right main burners are ignited by using the right side igniter (Fig. 26).
5. If the burner does not light on the second try, turn the control knob to OFF and wait 5
minutes for the gas to clear, and then try match-lighting the burner.
Match Lighting - Main Burners
1. Strike and place the burning long wooden match (or butane lighter with extension) through
the spaces in the grill grates near the ports of the back crossover burner between the heat
tents. (Fig. 27).
2. Push and turn the control knob counterclockwise to the "HIGH" position.
3. Repeat steps 1 and 2 to light the remaining burners.
Use a LONG wooden match or a butane lighter with an extension. Make sure all burner
controls are off except for the burner being lighted. If a long-reach match or lighter is not
accessible, there is a match extension provided, attached to the inside of the door. Insert
a match in the holder end of the extension, strike and place the burning match near the
BURNER being operated.
Lighting Side Burner
The side burner cover MUST BE OPEN during lighting and while using the side
burner (Fig. 28). NEVER operate the side burner with the side burner cover in the
closed position.
1. Push and turn the side burner control knob counterclockwise to the "HIGH" position.
(Fig. 28)
2. Immediately press and hold the electronic igniter button (Fig. 28).
You will hear a snapping sound.
3. If the burner does not light in 4 seconds, turn the control knob to OFF and wait 5 minutes for
the gas to clear before trying again.
4. If the burner does not light on the second try, turn the control knob to OFF and wait 5
minutes for the gas to clear, and then try match-lighting the side burner.
Match Lighting - Side Burner
Use a LONG wooden match, match extension, or butane lighter with extension.
1. Strike and place the burning long wooden match (or butane lighter with extension) through
the spaces in the pot support to the ports of the burner (Fig. 29).
2. Push and turn the side burner control knob counterclockwise to the "HIGH" position.
• The grill must be level before using the side burner.
• NEVER move the grill with a pot or pan on the side burner.
• Make sure the pot or pan is centered on the side burner.
• To avoid the possibility of tipping over the grill, NEVER place more than 15 pounds on
the side burner. A filled 6-quart aluminum pot weighs approximately 15 pounds.
18
CAUTION
CAUTION
CAUTION
WARNING
Fig. 24
Fig. 25
Fig. 26
Fig. 27
Fig. 28
Fig. 29