Coleman 8350 Series Assembly Manual page 23

Care, Maintenance and Cleaning
Replacing the Electrode Module
Steps For Replacing the Electrode Module:
1. Remove the cooking grates and the heat tents and set aside.
2. Using a 1/4" hex nut driver, remove the self-tapping screws holding
the front heat shield (Fig. 33 and 34). Set the front heat shield
aside.
3. The electrode module is now visible. Remove the three wires that are
factory installed from the electrode module to the burner electrodes
(Fig. 35).
4. To remove the electrode module, unscrew the igniter button and remove the
AA battery. Next, unscrew the plastic hex nut from the electrode module
(Fig. 36).
5. Reverse the procedure to install a new electrode module.
NOTE: It does not matter which ignition wire goes to which tab on the
electrode module.
(continued)
Fig. 33
Fig. 34
Fig. 35
Electrode
Module
Wires
Fig. 36
23