Setting Terminal Parameters; Starting The Switch; Pre-Start Checklist - H3C S5170-EI Series Manual

Figure3-4 Finishing the driver installation
6. Connect the standard USB connector of the cable to the USB port of the configuration
terminal.
7. Connect the RJ-45 connector of the cable to the console port of the switch.

Setting terminal parameters

To configure and manage the switch through the console port, you must run a terminal emulator
program, such as TeraTermPro, on your configuration terminal. You can use the emulator program to
connect a network device, a Telnet site, or an SSH site. For more information about the terminal
emulator programs, see the user guides for these programs.
Configure the terminal parameters as follows:
•
Bits per second—9,600.
•
Data bits—8.
•
Parity—None.
•
Stop bits—1.
•
Flow control—None.

Starting the switch

Pre-start checklist

Before powering on the switch, verify the following items:
•
The power cord is correctly connected.
•
The input power voltage is as required by the switch.
3-4