Cleaning Lens, Viewfinder And Lcd Panel - Panasonic Lumix DMC-LC1PP Service Manual

8.3. HOW TO DISCHARGE THE CAPACITOR ON JACK-FLASH C.B.A.
CAUTION:
1. Be sure to discharge the capacitor on JACK-FLASH C.B.A.
2. Be careful of the high voltage circuit on JACK-FLASH C.B.A.
when servicing.
[Discharging Procedure]
1. Refer to the disassemble procedure and remove the necessary
parts/unit.
2. Put the insulation tube onto the lead part of resistor (ERG5SJ102:
1k /5W).
(an equivalent type of resistor may be used.)
3. Put the resistor between both terminals of capacitor on JACK-
FLASH C.B.A. for approx. 5 seconds.
4. After discharging confirm that the capacitor voltage is lower than
10V using a voltmeter.

8.4. CLEANING LENS, VIEWFINDER AND LCD PANEL

Do not touch the surface of lens, viewfinder and LCD Panel with your hand.
When cleaning the lens, use air-Blower to blow off the dust.
When cleaning the viewfinder and LCD Panel, dampen the lens cleaning paper with lens cleaner,
and the gently wipe the their surface.
Note:
A lens cleaning paper and lens cleaner are available at local camera shops and market place.
Fig. F1
14