Toro Z Master 4000 Series Operator's Manual page 28

Figure 38
1. Upper tube
2. Bagger opening
5. Measure the distance the tube is inside the
hood.
Note:
Measure from the hood plate to the edge
of the tube as shown in
needs to be 19 mm (3/4 inch).
Figure 39
1. Hood plate
2. Upper tube
3. Hood in the down position
6. Once the 19 mm (3/4 inch) measurement has
been achieved, mark the upper tube on the
outside where the rubber seal protrudes out
(Figure 40).
g376170
3. Bagger hood
Figure 39. This distance
g003388
4. 19 mm (3/4 inch)
5. Edge of tube
Note:
This is marked to ensure the correct
position for the upper tube when drilling the
holes and connecting the upper and lower tubes.
Note:
The rubber seal must protrude out from
the bagger hood.
1. Upper tube
2. Rubber seal protruding out 4. Mark here against the
28
Figure 40
3. Bagger hood
rubber seal.
g003393