V-TAC VT-521 Installation Manual

Recessed hanging emergency exit light

SAFETY:

• Installation of this luminaire should only be carried out by a qualiﬁed electrician or

competent person to the current IEE Wiring Regulations (BS7671)

• Please isolate mains prior to installation/maintenance

• Check the total load on the circuit, including when this luminaire is ﬁtted, does not

exceed the rating of the circuit cable, fuse or circuit breaker

• Please note the IP (Ingress of Protection) rating of this luminaire when deciding the

location for Installation

• This product is Class II double insulated

• This product is non-dimmable

INSTALLATION MANUAL

RECESSED HANGING EMERGENCY EXIT LIGHT

VT-521

WEEE Number: 80133970

Table of Contents

Do you have a question about the VT-521 and is the answer not in the manual?

Page 1 WEEE Number: 80133970 INSTALLATION MANUAL RECESSED HANGING EMERGENCY EXIT LIGHT VT-521 SAFETY: • Installation of this luminaire should only be carried out by a qualiﬁed electrician or competent person to the current IEE Wiring Regulations (BS7671) • Please isolate mains prior to installation/maintenance •...
Page 2 INSTALLATION: • Provide power to the required point of installation, • Cut a suitable aperture in the ceiling as per the cut-out details in Fig 1 ensuring that it does not infringe with electrical cables, water/gas pipes or ceiling joists Fig1 •...
Page 3 Live (brown) Neutral (blue) Fig 3 WARNING: • This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance testing. Irreparable damage will occur if this instruction is not followed • Recommended routine test procedure in accordance with BS5266 •...
Page 4 GENERAL: The LEDs ﬁtted in this product are non-replaceable. The unit should be recycled in the correct manner when it reaches the end of its life. Check local authorities for where facilities exist. Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the ﬁtting.