Setting Power Supply Voltage Of Target Interface - NEC IE-789136-NS-EM1 User Manual

3.4 Setting Power Supply Voltage of Target Interface

In the IE system, emulation is possible with a voltage of the same level as the power supply voltage of the target
system.
When the target system is not connected, the IE system automatically operates with the emulator's internal power
supply (5 V).
When debugging with a voltage that is the same level as that of the target system, supply the same voltage as that
of the target system to the TP1 terminal pin of the IE-789136-NS-EM1 (the same applies when the voltage is 5 V).
Set the target voltage to between 1.8 and 5.0 V.
• Maximum current consumption of TP1
1.8 to 5.0 V: Approximately 100 mA
Figure 3-10. Connection of TP1 and Power Supply Voltage of Target System
IC6
IC7
LED1
Emulation probe
Target system
Caution Connect TP1 on the board and the power supply voltage of the target system after turning off the
power of the IE-78K0S-NS or IE-78K0S-NS-A.
Remark The V pin of the target system is only used for controlling LED1 (TV
DD
power supply of the target system is connected in the IE-789136-NS-EM1.
28
CHAPTER 3
SW1
CN2 36GS
User's Manual U14363EJ2V0UM
INSTALLATION
X1
TP1
Low Volt
GND
V
GND
DD
Power supply voltage of target system
CC
), which monitors whether the