Poi On Route; Turn-By-Turn List - Navigon N100 User Manual

User Manual NAVIGON Mobile Navigator
8.6

POI on Route

Specifying one of the points of interest as an interim destination
8.7

Turn-by-Turn List

- 74 -
At any time during the navigation process it is possible to display
points of interest located on your route from three specific
categories. The enables you to quickly find out how far the next
wayside is. Then you can add this wayside to your route as an
interim destination.
Note: Points of interest from the same categories that are also
available in the Direct Access will be shown. You can configure
these categories.
Refer to chapter "Categories for quick link and for POI on Route"
on page 90 for more information.
The map is opened in Navigation mode.
1. Tap on any point on the map.
2. Tap on the POI on Route button.
The POI R
ON OUTE
three categories the two next points of interest that are
located on or in the vicinity of your route.
The points of interest are arranged according to distance.
If you wish to drive to one of the displayed points of interest,
then tap on the
alongside its entry in the list.
The route is recalculated. The specified point of interest is taken
as the next route point.
You can view a detailed description of the route prior to starting
navigation. This list displays all of the driving instructions in table
form. Here it is also possible to block out individual route
sections. In this case a different route will be calculated.
You have specified a destination and tapped on the Start
Navigation button.
- OR -
You have planned or loaded a route and tapped on the Show
Route button.
window opens. It shows from each of the
(Interim Destination) button to the right

POI on Route