Page 3
Connections 1. Connect speakers together with supplied wire 2. Connect source - TV, Computer, Phono 3. Connect source - Bluetooth 4. Connect AC mains ELAC DEBUT ConneX DCB41 | www.elac.com | Page 3...
Page 4
SPEAKER OUT Power/Standby: The unit will standby after 15 minutes of no use. Pressing or rotating the volume knob as well as pressing power button on remote will wake up unit. ELAC DEBUT ConneX DCB41 | www.elac.com | Page 4...
If you choose to use the turntable’s Phono pre-amplifier, then ensure its switch is set to ON postion and DCB41 is set to OFF. The Ground connection is optional. It is recommended to be used as it can lower residual noise. ELAC DEBUT ConneX DCB41 | www.elac.com | Page 5...
Page 6
24118 Kiel, Deutchland HDMI (ARC) SPEAKER UPDATE ONLY SERIAL NUMBER PHONO ON/OFF SUB OUT CAN ICES-0003(B)/NMB-003(B) FCC ID: XXX-XXXXX IC: XXXXX-XXXXX Desinged by Elac Made in China ELAC DEBUT ConneX DCB41 | www.elac.com | Page 6 120-240V~50/60Hz AC SPEAKER OUT...
CONNECTIONS - BLUETOOTH When initial power up - BT LED will flash if nothing is paired to it. When LED is flashing, “ELAC DCB41” is visible on your device. Pairing can also be initiated as follows: Press and hold BT source on remote until LED flashes.
Desinged by Elac Made in China will be the RIGHT speaker. CAN ICES-0003(B)/NMB-003(B) FCC ID: XXX-XXXXX IC: XXXXX-XXXXX 120-240V~50/60Hz AC SPEAKER OUT Desinged by Elac Made in China 120-240V~50/60Hz AC SPEAKER OUT ELAC DEBUT ConneX DCB41 | www.elac.com | Page 8...
Connect the speaker(s) according to the instructions in the manual. • Many ELAC speakers are equipped with spikes and/or anti-slip feet. They are explicitly provided for leveling the speaker. For leveling on an uneven floor, unscrew the spikes or anti-slip feet by 2-3 turns of thread.
Page 10
ELAC AMERICAS INC. ELAC ELECTROACUSTIC GMBH 1938 N. BATAVIA St. SUITE K FRAUNHOFERSTRAßE 16 D-24118 KIEL, GERMANY ORANGE, CA 92865...