Hardware Installation - Grandstream Networks GSC3506 Quick Installation Manual

GSC3506 PORTS AND BUTTONS
Ceiling
hole
2
1
3
Back panel
NO. Port Label Description
1 USB Port USB2.0, External USB Storage
Ethernet RJ45 port (10/100Mbps) supporting PoE/
2 NET/PoE
PoE+.
2-pin switch-in input port
3 2-Pin port
Alarm-in input port (Access voltage 5V to 12V)
Factory reset button.
4
Reset Press for 10 seconds to reset factory default
settings.
5 Volume Sound Volume buttons.

HARDWARE INSTALLATION

GSC3506 can be mounted on the ceiling or the Boom. Please refer to the following
steps for the appropriate installation.
Ceiling Mount
1. Drill a round hole
230mm
with a diameter
of 230mm or use
9in
the Mounting Hole
Cut-Out Template.
4
Front panel
(Mesh cover removed)
1
or
~3~
Installation using Ceiling Bracket Kit (*sold separately)
5
2. To ensure safety, install first the anti-fall
ropes, then plug in the Ethernet and 2-pin
cables.
4. Align the device with the hole and push up
slowly with two hands.
Warning: Avoid pressing the horn with your hands.
3
2
6. Align the notch on the front cover with the
notch on the device, press the whole front
cover to ensure that each buckle is fastened.
406~605mm
（16~23.8in）
Must attach
Note: The anti-fall rope diameter must
be less than 5mm, and the pulling force
must be greater than 25kgf.
3. Open the front cover with a flat-head screwdriver.
3
4
4
5. Use a screwdriver and gently rotate
5
clockwise the screws marked as (1), (2),
(3) and (4) in the step 5 illustration.
1
Warning: If you use an electric drill, make sure to adjust
it to the minimum speed gear first.
6
~4~
Fix the Ceiling Bracket
using the screws from
the kit as show in the
illustration.
2