QSC AcousticDesign Series Hardware User Manual page 5

Mount the Loudspeaker
Refer to Figure 5.
1. Make sure all of the dog-ears are fully extended and in their non-capture position.
2. Position the loudspeaker into the hole prepared in the ceiling.
3. Use a Phillips screwdriver to tighten each of the three dog-ear screws. As you tighten the screws, the dog-ears will swing into
capture position over the ceiling. Be sure all dog-ears are properly positioned over the ceiling.
4. Tighten the dog-ears until firm contact is made with the ceiling surface.
CAUTION: Do not overtighten the dog-ear screws.
5. Insert the grille safety tether grommet into supplied hole on the loudspeaker baffle and install the grille.
1
Dog-ears against loudspeaker
2
Turn the screw clockwise to engage the
dog-ear with the ceiling.
5
— Figure 5 —