Operation; Maintenance - Sealey POWER TOOLS MS600P Instructions

5.

OPERATION

WARNING! Ensure you read, understand and apply the safety instructions in Section 1.
Ensure the power control switch (fig 4.B) is NOT locked on before plugging into the mains.
p
5.1. MS600P
Speed for polishing: Switch position (I) low 1900rpm.
Speed for sanding:
5.2. MS700PS
Speeds for polishing
Speeds for sanding:
WARNING! On both models, the high speed setting is intended for sanding. If used for polishing an excessive amount of
surface material may be removed.
p
Note: As the rubber support disc is flexible , when sanding it should not be used head on, but at an angle of approximately
10 to 20 degrees.
Contact your Sealey Dealer for details of compound heads and lambswool bonnets.
6.

MAINTENANCE

WARNING! Before attempting any maintenance ensure the unit is unplugged from the mains power supply.
p
WARNING! Wear approved safety eye protection and. if necessary, respiratory protection.
p
The following maintenance must only be carried out by a technically qualified person or an authorised Sealey service agent.
Heavy Duty Polisher & Polisher
Models MS600P & MS700PS
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
01284 757500
Switch position (II) fast 2400rpm.
Positions 1 = 570rpm.
Positions 5 = 2290rpm.
Declaration of Conformity
For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Tools.
INFORMATION:
Sealey Group
01284 703534
2 = 930rpm. 3 = 1450rpm.
6 = 2750rpm.
WARRANTY:
E-mail: sales@sealey.co.uk
fig. 4
4 = 1860rpm.