Sealey POWER TOOLS MS600P Instructions

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
The use of symbols in this document is to attract your attention to possible danger. The symbols and warnings themselves do not eliminate any danger, nor are they substitutes for proper
accident prevention measures.
1.

SAFETY INSTRUCTIONS

1.1.

ELECTRICAL SAFETY.

p WARNING! It is the user’s responsibility to read, understand and comply with the following:
Electricity At Work Act 1989
Health & Safety at Work Act 1974
Important:
a) Connect the GREEN/YELLOW earth wire to the earth terminal ‘E’.
b) Connect the BROWN live wire to live terminal ‘L’.
c) Connect the BLUE neutral wire to the neutral terminal ‘N’.
After wiring, check there are no bare wires, that all wires have been correctly connected, that cable outer insulation
extends beyond the cable restraint and that the restraint is tight.
To re-wire, connect the brown & blue wires as indicated above. DO NOT connect the brown or blue to the earth terminal.
Cable extension reels
1.2

GENERAL SAFETY

WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.
p
WARNING!
3
p
3
WARNING!
3
p
3
3
3
WARNING!
3
p
You must
If in any doubt about electrical safety, contact a qualified electrician.
subject to 1.1.10. below),
Ensure the unit is correctly earthed via a three-pin plug.
Use genuine parts only. Non-authorised parts may be dangerous and will invalidate the warranty.
HEAVY DUTY SANDER & POLISHER
MS600P & MS700PS
MODELS:
Yellow & Green
Earth wire
Blue
Neutra
l
FUSE RATING
THIS PRODUCT MUST BE FITTED
WITH A
13 AMP FUSE
Brown
Live
wire
Cable
restrai