Light - Hisense RS-77WC1SQD/UPE-001 Service Manual

23

6.5 Light

6.5.1 Basic parameters
Rated voltage:DC12V
Rated power:5W
6.5.2 Checking method
1.Check the connecting wiring between light and main control board is well or not, repair
if it is broken.
The light corresponding pin No.4 and No.5 on 5 pins connector of mainboard.
2.Check output voltage corresponding light of the main control board, if it is 12V when
working conditions are met, it means the mainboard is OK, change the light; If not, it
means the main control board is broken, change it.
6.5.3 Removing the light
1. Unplug the appliance
2. Pry up the light cover with a pin or other spikers as picture 1.
2. Catch the light cover with one hand and pull down it as picture 2.
3. Take the LED light out and unplug the terminal as picture 3 and 4
Picture1
Picture3
6.6 Door switch
6.6.1 Basic parameters
Load voltage: DC 5V
6.6.2 Checking method
1. Check the connecting wiring of door switch is well or not, repair if it is broken.
Picture2
Picture4