Advertisement
Step 2: NHT Third Foot for Center Channel Use
The M5 and M6 cartons include a "Third Foot",
a support that stabilizes the monitor when it is
mounted on a television. If the top of the televi-
sion is shallower than the Monitor is deep, the
rear of the Monitor will not be fully supported.
The Third Foot will provide the necessary sup-
port in this case. The Third Foot can also be
used to aim the Monitor down towards the lis-
tening area if the television is significantly above
eye level.
There are two parts supplied with the Third Foot
for assembly: (2) plastic washers and (2) thumb-
screws. The plastic washers go between the
Third Foot and the cabinet to protect the cabi-
net's lacquer finish. Assemble these parts as
shown and screw the two thumbscrews partially
into the two threaded holes next to the terminal
plate.
Attach two rubber feet about an inch from the
bottom front edge of the monitor. Set the moni-
tor on the television and adjust the length of the
Television
third foot so that it rests on the TV set as shown.
Hand tighten the thumbscrews.
Note: if the center channel is to rest flat on the
TV or shelf, use all four rubber feet (on in each
corner of the bottom surface of the speaker)
Step 3: Logo Placement
The M5 and M6 are supplied with a metal NHT
logo that can be attached to the grilles when the
speakers are placed in the vertical position only.
The logo should be attached at the bottom of the
grille. To attach the logo, hold the grille up to a
light to locate the two holes in the frame through
the cloth. Line up the two posts on the back of
the logo with the holes and press the logo firmly
through the cloth and into the grille frame until it
is fully seated against the grille.
Note: The logo badge is not to be attached
when the speaker is placed horizontally.
Advertisement
