Advertisement
Step 4: Install Wire Channel Assembly
The wire channel assembly for the P5 and P6
pedestals neatly routes the speaker wire down
the back of the pedestal. It consists of two plas-
tic U shaped brackets, one plastic channel and
four 6-3/4 screws.
To install, first strip ½" - ¾" of insulation from the
ends of your speaker wire and connect them to
the monitor's binding post by loosening the bind-
ing post nuts and slipping the wire into the hole
behind each nut. Tighten the nuts with your
NHT wrench. Remember to check for the cor-
rect polarity (see section 5.2 and 5.3).
Slip the speaker wire into the channel. The
brackets are recessed on one side to accept the
ends of the wire channel.
The recesses in the brackets should face each
other when the channel is installed. There are
small pilot holes in the rear of the pedestal to
accept the 6-3/4 bracket screws. Fasten the
channel to the pedestal with the brackets and
the four screws as
shown.
Recess
Bracket
Channel
Step 5: Install Spikes (optional)
Spikes provide additional stability when the
pedestal is placed on thick carpet or on an
uneven surface.
Position the speakers in or
close to their permanent location before
installing the spikes. It is difficult to move the
speakers once the spikes are in place.
Install the locking nuts on the threaded spikes
and screw them all the way down the shaft until
they stop. Attach the spikes on one side of the
pedestal at a time. Tilt the pedestal as shown in
the photograph and screw the metal spikes into
the bottom of the aluminum stabilizer bars.
Tighten the locking nuts by hand. Move to the
0
1
Advertisement
