Advertisement
8.
DO NOT use any tools. Press the sides of the 0-ring on the hatch to create a protru-
sion. Pull the protruding part of the 0-ring over the threads and remove.
9.
Take the new 0-ring (U.S. Divers PN 8200-23) and lightly lubricate it with silicone
grease (Dow Corning 111 recommended) and wipe off the excess. DO NOT USE
SILICONE SPRAYS.
10. Install the 0-ring in groove on hatch being careful not to cut the 0-ring on the threads.
New Battery Installation
11. Place the first battery, plus (+) side up, into the compartment. Try not to get skin oils
on the battery contacts. Wipe clean before insertion.
12. Put the second battery, also plus (+) side up, on top of the other battery. Make sure
that the upper gold battery contact rests against the SIDE of the battery, not on top.
13. Replace the battery hatch (make sure 0-ring is installed) and tighten hand tight with a
nickel, or quarter. DO NOT use a screwdriver.
14. Activate the Pivot(r) DS3 to test the battery connection.
15. To insert the module back into the rubber boot, you first want to orient the gauge
straight up and down. Insert the gauge into the upper section at a 45 degree angle
and then press into place.
Installing a Compass into the Pivot Console Boot
1.
Using your thumb, pull back one of the lower corners of the rubber boot (see figure 9).
While holding the corner back, lift out the slate.
2.
If the console has been used, clean the boot in warm, soapy water to remove any
sand, salt, or dirt. Rinse in fresh water and dry before installing the compass.
3.
How you wish to "sight" your compass will determine the orientation of the side scan
window of the compass module in the rubber boot. The side window will face either
the rear of the console, or the side of the console. Place the compass into the boot as
shown in figure 10.
2. Install compass
1. Pull back corner
Advertisement
