Electrolux EWF8025EGWA User Manual page 32

32 www.electrolux.com
In this case, make sure the end
cannot come unhooked when the
machine will be emptied. This
could be done by tying it to the tap
with a piece of string or attaching
it to the wall.
In a sink, drain pipe branch.
This branch must be above the trap
so that the bend is at least 60 cm
above the ground.
Max.
90 cm
Min.
60 cm
Push the drain hose onto the spigot
and secure with a clip, ensure a
loop is formed in the drain hose to
prevent waste from the sink
entering the appliance.
If the outlet spigot has not been
used before, remove any blanking
plug that may be in place.
Directly into a drain pipe, at a height of
not less than 60 cm and not more
than 90 cm.
Max. 90 cm
Min. 60 cm
The end of the drain hose must
always be ventilated, i.e. the inside
diameter of the drain pipe must be
larger than the outside diameter of the
drain hose.
The drain hose must not be twisted or
curled. Run it along the oor; only the
part near the drainage point must be
raised.
For the correct functioning of the
machine, the drain hose must remain
hooked on the proper support piece
situated on the top part of back side
of the appliance.
11.5 Electrical Connection
This machine is designed to operate on a
220-240 V, single-phase, 50 Hz supply.
"An incorrect power supply may void
your warranty."
Check that your domestic electrical
installation can take the maximum load
required (350 W), also taking into
account any other appliances in use.
CAUTION!
Connect the machine to an
earthed socket outlet.
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the
above safety precaution.
Should the appliance power
supply cable need to be replaced,
this shall be carried out by our
Service Centre.