Electrolux EWF8025EGWA User Manual page 16

16 www.electrolux.com
5.2 Interruption Of A Program
- To pause press Start/ Pause. The
indicator will start flashing.
- Press the Start/Pause again. The
program will continue.
5.3 Changing A Program
Changing a running program is possible
only by resetting it.
1. Turn the program selector knob to the
position "Off" to cancel the program
and to turn off the appliance.
2. Turn the program selector knob to
the new program position and set the
new option, then press "Start/Pause"
touchpad again.
5.4 Changing The Options
It is possible to change only some option
after the program has started.
1. Press the touchpad Start/Pause.
The indicator will start flashing.
2. Change the options.
3. Press Start/Pause again. The program
will continue.
5.5 Opening The Door
While a program or the Delay End is
operating, the appliance door is locked
and the door lock indicator "
First set the machine to PAUSE by
pressing the "Start/Pause" touchpad.
Wait until the door lock indicator "
goes off, then the door can be opened.
If the door lock indicator "
disappear, this means that the machine is
already heating and the water level is
above the bottom edge of the door or the
drum is turning. In this case the door
CAN NOT be opened. If you need to
open it, you must drain the water to
open the door.
The appliance will not drain the
water.
5.6 At The End Of The Program
" is on.
"
" does not
To drain the water, you have to
switch the machine off by turn the
program selector knob to the
position "Off" to deactivate the
appliance. Turn On the machine and
select "Spin" program, you can
select "No Spin ", if you want the
machine to only drain the water
then press Start/Pause touchpad to
start the program.
-
The appliance stops automatically.
-
The acoustic signal will operate.
-
The display will show "
-
The indicator of the Start/Pause
touchpad goes off.
-
The door lock indicator "
goes off.
-
Remove the laundry from the
appliance. Make sure that the
drum is empty.
- Keep the door ajar, to prevent
the mildew and odours.
-
Turn off the water tap.
At the end of the program, the
time remaining can suddenly
decrease from 7 minutes or less
to 0 due to the overestimated
total program time during the
load sensing phase. In some
cases (with perfectly balanced
load) the program time can be
shorter than the time estimated
after the load sensing phase is
completed. This is a normal
behavior of the machine and not
a cause for concern as it does
not compromise its
performance.
".
"