Electrolux EWF8025EGWA User Manual page 26

Table of Contents

Advertisement

Available languages

Available languages

26
www.electrolux.com
Malfunction
The machine
fills then
empties
immediately:
The machine
does not
empty
and/or does
not spin:
There is water
on the floor:
Unsatisfactory
washing
results:
The door will
not open:
Possible cause
The end of the drain hose is
too low.
Error code:
.
The drain hose is squashed
or kinked. Error code:
The option "Rinse Hold
or "No Spin
" has been
selected.
The laundry is not evenly
distributed in the drum.
Too much detergent or
unsuitable detergent
(creates too much foam) has
been used.
Check whether there are any
leaks from one of the inlet
hose fittings. It is not always
easy to see this as the water
runs down the hose; check
to see if it is damp.
The drain hose is damaged.
Water leaks inside the
machine. (code:
Too little detergent or
unsuitable detergent has
been used.
Stubborn stains have not
been treated prior to washing.
Excessive laundry load.
The program is still running.
There is water in the drum.
This problem may be caused
by a failure of the appliance.
Solution
Refer to relevant paragraph
in "water drainage" section.
Check the drain hose
.
connection.
Press Start/Pause touchpad to
"
drain the water or select spin
program.
Pause the machine and
redistribute laundry manually.
Reduce the detergent
quantity or use another one.
Check the water inlet hose
connection.
Change it with a new one.
Disconnect the main plug from
)
the main socket. Turn off the
water tap. Contact your local
Service Centre.
Increase the detergent
quantity or use another one.
Use commercial products
to treat the stubborn stains.
Reduce load.
Wait until the end of washing
cycle.
You must drain the water to
open the door (refer "Opening
The Door" on page 16).
Contact Service.

Advertisement

Table of Contents
loading

Table of Contents