Advertisement
SET UP INSTRUCTIONS
1. Valve operation
Screw out the lid with valve wrench, then the center valve pin is appeared. You can close/open the valve by pressing it
once and again. Please refer to below images.
2. To inflate the trampoline, please follow the below steps
A). Inflate product through each vales according to the sequence marked on the information symbol nearby vales.
B). Unscrew the valve cap and press down on the pin to open the valve. Let the air flow naturally into the product, then
press down on the pin again to close the valve (in the UP position).
C). Attach the hand-operated pump hose clockwise onto the valve, and pumping air into the trampoline.
D). After fully inflating, screw the valve lid and tighten it with plastic wrench.
3. To deflate the trampoline, screw out the valve lid with plastic wrench, then press the valve central pin to let it is in open
position, please be careful of any sand or debris around the valve area when deflating as the small particles could become
airborne together with the release of the air pressure.
USE INSTRUCTIONS
The water trampoline can be set up in minutes with the included hand-operated pump, and it has the handles, which are
convenient for moving or transport. The ladder is for easy climb up and down. The sand bag is designed to keep it balance
in water while climbing by ladder, It can be filled with the maximum 20kgs sand or weights (not included), and connected
to the D-ring which located at the opposite position of the ladder while using on water.
Note: 1). Only allow a maximum of 1 user at one time, and The maximum user weight is 70kgs.
2). Always jump in the jumping area.
3). The trampoline can be fixed on the water through a rope (not included) by tied between the D-ring at the
bottom and locking device.
4). Use the included latch fastener on the sand bag to connect it with the D-ring together directly while using.
REPAIR INSTRUCTIONS
If a chamber is damaged, use the provided repair patch.
1.Completely deflate the product.
2.Clean the damaged area, and let it dry completely.
3.Cut a piece from the repair patch, ensure it is larger than the area to be repaired and no rounded corners to prevent
peeling.
4. Apply the vinyl repair glue sparingly to patch, spreading out it evenly all over, then cover to the damaged area and smooth
out any air bubbles.
5.Place a weight on the repaired area, and allow 24hours to reach full bond strength.
CLEANING AND STORAGE INSTRUCTIONS
1. After deflation, use a damp cloth to gently clean all surfaces.
product.
2. Store in a cool, dry place and out of children's reach.
3. Check the product for damage at the beginning of each season and at regular intervals when in use.
FOR AU/NZ: IMPORTED FOR KMART STORES IN AUSTRALIA AND NEW ZEALAND.
Don't use solvents or other chemicals that may
Made in China
damage the
Advertisement
