Advertisement
Care and Maintenance
□
Make sure the unit is turned OFF and is unplugged, and the heating elements of heater are cool whenever you are cleaning the heater.
□
Clean the metal trim using a water-dampened soft, clean cloth. DO NOT use brass polish or household cleaners, as these products will
damage the metal trim.
□
lubrication. However, periodic cleaning/vacuuming of the fan/heater and air intake/output vents is recommended.
□
Any other servicing should be performed by an authorized service representative.
WARNING: Make sure the power is turned off before
proceeding. Any electrical repairs or rewiring of this
unit should be carried out by a licensed electrician in
accordance with national and local codes.
WARNING: If repairing or replacing an electrical
component or wiring, the original wire routing, color coding
and securing locations must be followed.
WARNING: Electrical outlet wiring must comply with local
building codes and other applicable regulations to reduce
WARNING:
the electrical system.
NOTE: When the heater is not in use, the heater should
be stored in a dry location, away from possible damage.
The power cord should be stored properly to avoid
contact with hot or sharp objects.
Replacing the Remote Control Batteries
When the remote control stops operating or its range seems reduced, it is time to replace the batteries.
1.
Locate the battery compartment on the back end of the remote control.
2.
Slide the battery door open and remove the old batteries. .
3.
Insert 2 AAA batteries.
4.
Do not mix old and new batteries; do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.
5.
Re-insert the battery door.
NOTE: The batteries should be removed if the product
is to be left unused for a long time.
CAUTION: Do not attempt to recharge a non-rechargeable
battery. Remove the exhausted battery from the product.
WARNING: Disconnect power before attempting any
shock or personal injury.
WARNING: During any service of this appliance, the
power to the unit must be turned off. First turn the main
power switch to the "OFF" position. Then remove the
electrical plug from the wall outlet.
10
Advertisement
