Electrolux FOM 71 CLS Maintenance Manual page 11

Installation inspection of the reference machine
Wascator FOM 71 CLS
Installation inspection of the
reference machine
Before carrying out any major test series inspect
the installation and check the following terms:
• The machine must be installed on a level
base. The following clearances are recom-
mended in order to facilitate calibration:
At least 500 mm between the machine and
1
the wall behind and min. 50 mm on both
sides of the machine whether installed next to
the wall or other machines.
• Check the levelling of the machine. The verti-
cal difference from corner to corner of the top
lid shall not exceed 5 mm. If not adjust the
feet of the machine.
• The machine shall be connected using the
supplied Y hose or using two single hoses.
• The water hose and power cable must hang
freely between the machine and wall in order
to prevent disrupting the reference machine
scale system.
• Make sure that the drain installation is made
according to the information on next page.
Observe the required air gap in the drain sys-
tem.
1
3:1
5710 A