Related Manuals for Powerwave Technologies G3L-1900-31
Summary of Contents for Powerwave Technologies G3L-1900-31
- Page 1 1930-1990 MHz Operation Manual G3L-1900-31 (DC) / G3L-1900-31-A (AC) Wideband Multi-Carrier Power Amplifier Operation Manual 1930 MHz – 1990 MHz 044-05116 Rev. A June 2002...
- Page 2 © 2002 Powerwave Technologies Incorporated. All rights reserved. Powerwave Technologies, and the Powerwave logo are registered trademarks Powerwave Technologies, Inc. reserves the right to make changes to the documentation and equipment, including but not limited to component substitution and circuitry changes. Changes that impact this manual may subsequently be incorporated in a later revision of this manual.
-
Page 3: Section 1 General Description
G3L-1900-31/G3L-1900-31-A Operation Manual Section 1 General Description 1-1 Introduction This manual contains information and procedures for the operation of the model G3L-1900-31 and G3L-1900-31-A Wideband (WCDMA) Multi-Carrier Power Amplifier (MCPA). The manual is organized into the following sections and appendix. - Page 4 BIT0=LSB, BIT!=MSB WPA_ID_BIT2 OPEN=1=Logical High Gnd=0=Logical Low Ground Connected to WPA chassis ground Free 6, 7, 14. 15, 16, Reserved for WPA manufacture 22, 23 Ó Copyright Powerwave Technologies, Inc., June 2002. All rights reserved 044-05116 Rev. A June 2002...
- Page 5 The WPA monitors the internal temperature. The measured temperature must represent the base plate temperature of the main power amplifier. The alarm is given according to the limits listed in table 1-5. Ó Copyright Powerwave Technologies, Inc., June 2002. All rights reserved 044-05116 Rev. A June 2002...
-
Page 6: Status Indicator
TCP/IP connection is lost and WPA is in standby state 1-6 Functional And Physical Specifications Functional and physical specifications for the model G3L-1900-31 and G3L-1900-31-A amplifiers are listed in appendix A. Ó Copyright Powerwave Technologies, Inc., June 2002. All rights reserved 044-05116 Rev. -
Page 7: Equipment Changes
G3L-1900-31/G3L-1900-31-A Operation Manual 1-7 Equipment Changes Powerwave Technologies, Inc. reserves the right to make minor changes to the equipment, in- cluding but not necessarily limited to component substitution and circuitry changes. Changes that impact this manual may subsequently be incorporated in a later revision of this manual. To that end, we ask that you, our customer, share with us any information acquired in field situations that would enhance this manual. -
Page 8: Section 2 Operation
G3L-1900-31/G3L-1900-31-A Operation Manual Section 2 Operation 2-1 Introduction This section contains operating instructions for the G3L-1900-31 or G3L-1900-31-A wideband power amplifier (WPA). 2-2 Initial Start-Up and Operating Procedures The manual main power supply ON/OFF switch is located on the WPA front panel (refer to figure 1-1 and paragraph 1-5 for status indicator conditions). -
Page 9: Appendix A. Specifications
10 MHz lower than the lowest carrier in the operating band. Ó Copyright Powerwave Technologies, Inc., June 2002. All rights reserved All specifications are subject to change without notice. Contact the factory for complete performance data.
Need help?
Do you have a question about the G3L-1900-31 and is the answer not in the manual?
Questions and answers