Table of Contents
Advertisement
Braille Box
3.3
Power on/off
Power on the embosser by following these steps:
o Insert the power connector into the embossers power input.
o Connect the power cable to a grounded power outlet.
o Press the ON key on the control panel for 2 seconds to power on the V4 embosser. It
takes approximately 40 seconds while the fan blows and the start up sequence is
completed. The embosser is ready to use after it echos the brand name.
Power off the embosser by holding the OFF key on the control panel for 2 seconds. This is
verified by echo: "Embosser is shutting down".
The embosser should always be powered off before disconnecting the power cord. This to
avoid the issue of improperly closed files.
3.4
Speech feeeback
The speech feedback uses the English speech by default and may be changed into other
languages from control panel. By inserting a standard headphone or external speaker you may
increase the speech quality. The headphone connector is located on the back side of the
embosser.
3.5
Index Braille printer driver
Index software and printer drivers for Index Braille embossers may be installed from the USB
memory stick included in the shipment or from www.indexbraille.com.
If any issues occur when installing the latest Index Printer driver, please contact
support@indexbraille.com
© 2015 Index Braille
1. Fuse 6,3 A/250V slow blow
2. Power input 90-250V
3. Green LED = CPU OK
4. Reset / System reset = 3 seconds reset to
factory settings
5. Red LED = CPU error
6. Service serial port
7. USB port 2.0
8. Network port with LED (100 MB)
9. Headphone
Installation
6
www.indexbraille.com
Advertisement
Table of Contents
