Select Layout - Index V4 Manual

15 Index V4 Embosser manual
DOUBLE
KEYS
(press keys
with half a
second
interval
between)
LONG
KEYS
5.2

Select layout

Select on of five alternative layouts containing paper sizes, top margin, binding margin, lines per
page, line length and characters per line, from the control panel.
To select layout 1, 2, 3, 4 or 5
Press arrow UP/DOWN on the control panel of the embosser to start Set Layout, echo: "Set
layout, current value is 1(or 2,3,4,5) paper size (of this layout)".
Press HELP to identify the paper size, duplexing, characters per line, lines per page.
Press OK to save the new layout.
Basic-D (Index factory layout 1-5 when shipped)
Layout
1
Basic-D
default
www.indexbraille.com
OFF+FEED Stop embossing
Basic-D only, will place paper in emboss position
FEED+FEED
FEED+OFF Basic-D only, will reverse the paper out of the embosser
Braille Box only, will place the paper arms in horizontal
HELP+FEED
position.
Echo stating number of lines per page and characters per
HELP+MENU
line
Toggle between local and English speech feedback,
HELP+CHS
temporary language use
HELP+10 Echo embosser IP-address
Emboss hammer test page
HELP+ON
HELP+OFF Emboss current format settings defined in Braille layout
HELP+HELP Emboss embosser information page in letter graphics
Start command center
10+1
Start service center
1+10
(Pin-code protected, contact support@indexbraille.com)
ON Power on the embosser
(2 seconds)
OFF Power off the embosser
(2 seconds)
To start, will begin beeping from 3 to 15 sec followed by
speech feedback "remote support enabled".
The V4 embosser has to be equipped with firmware 1.3.5
HELP
or higher and be connected to the Internet with the IP-port
(15 Seconds)
with DHCP on. After remote support is started, Index
support may control this embosser remotely. Contact
support@indexbraille.com
Paper Lines per
size page
W11 x L12" 29
for further information.
Top Characters
margin per line
0 41
Binding
Duplexing
Margin
4 Double-sided
© 2015 Index Braille