Removing / Installing The Cheek Pads; Removing / Installing The Head Liner - BRP PYRA User Manual

B. THE HELMET
REMOVING THE CHEEK PADS
1. Unfasten the 3 snaps to remove the
first part of the pad.
2. Slide out the chinstrap to remove
cheek pad completely.
3. Repeat these steps for the other
side.
INSTALLING THE CHEEK PADS
1. Before installing the cheek pads,
identify the right and the left sides.
2. Fasten the 3 snaps in position. Make
sure the strap is in position inside the
cheek pad notch.
3. Repeat these steps for the other
side.
REMOVING THE HEAD LINER
1. The head liner is attached to the
inner shell with 2 snaps (on rear section
of the helmet).
2. The frontal portion, with 2 snaps.
They can be removed by pulling them
out carefully.
For the frontal portion, start to pull from
one side of the plastic strip.
3. Next, pull the upper part of the head
liner, to detach the Velcro .
TM
7