80
OPERATION
30 seconds if
is switched on.
ically
Turn indicators flash once.
Confirmation tone sounds
once (if programmed).
DWA is switched off.
Adapting DWA
Switch on the ignition (
Navigate to
Vehicle settings
select
Alarm system
The following adaptation set-
tings are available:
Adapt
Warning signal
Switch
Tilt sensor
off
Switch
Arming tone
off
Switch
Arm automatically
on or off
Possibilities for adjustment
Warning signal
rising and falling or intermit-
tent alarm tone.
Tilt sensor
sensor to monitor the inclina-
tion of the vehicle. The anti-
theft alarm (DWA) is tripped if
any attempt is made to steal
a wheel or lift the vehicle for
towing, for example.
When the vehicle is go-
ing to be transported, de-
activate the tilt sensor to pre-
Arm automat-
,
Settings
and
.
on or
on or
: Set the
: Activate tilt
vent the anti-theft alarm (DWA)
from being triggered.
Arming tone
turn indicators flashing, alarm
tone sounds as confirmation of
activation/deactivation of the
DWA.
Arm automatically
67).
matic activation of the alarm
function when the ignition is
switched off.
AUTOMATIC STABILITY CON-
TROL (ASC)
Switching ASC function off
and on
Switch on the ignition (
Navigate to
sist
Deactivate
off Automatic Stability Con-
trol (ASC) temporarily until
the next time the ignition is
switched on.
shows.
Activate
on Automatic Stability
Control (ASC). Alternatively:
Switch the ignition off and
then on again.
goes out; if self-diagnosis
has not completed it
starts flashing.
For more information on
Automatic Stability Con-
: In addition to
Settings
and select
ASC
to switch
ASC
to switch
ASC
: Auto-
67).
,
As-
.