Table of Contents
Advertisement
4.3 Memory installation
This mainboard supports DDR200/DDR266 DDR memory ， you may install
64/128/256/512MB 184 pin DDR memory。DDR SDRAM uses additional power and
ground lines and requires 184-pin 2.5V unbuffered DIMM module rather than
the 168-pin 3.3V unbuffered DIMM used by SDRAM.
Follow these instructions to install the Memory:
1.Push the latches on each side of the DIMM slot down.
2.Align the memory module with the slot. The DIMM slots are keyed with
notches and the DIMMs are keyed with cutouts so that they can only be
installed correctly.
3.Check that the cutouts on the DIMM module edge connector match the notches
in the DIMM slot.
4.Install the DIMM module into the slot and press it firmly down until it
seats correctly. The slot latches are levered upwards and latch on to
the edges of the DIMM.
5.Install any remaining DIMM modules.
12
Advertisement
Table of Contents
