Advertisement
When you first set up your printer, follow these simple steps to properly configure your printer to
FOR USING A TICKET WITH BLACK MARK/HOLE
Measure target Ticket Length (C), and distance from cut line to Top of Mark (D) in millimeters (mm)
Find the ITK12 driver icon (different paths depending on
version of Windows), and open the "PA ITK12G Properties"
driver utility
Select "General" tab
Select "Preferences"
Select preferred orientation, then select "Advanced" button
Under "Paper Size", select correct ticket size, press "OK"
Press "Apply" button
Select "Stored Printer Settings" tab in driver
With printer ON, select "Read" button to load current
printer settings
Under "Mark Type", set to "Black Mark" or "Hole/Silicon"
Enter Ticket Length (C) and Top of Mark (D) measurements
If the printer does NOT have a presenter, the Presenter
Mode will be grayed out and blank
Select "Update" button, wait until loading is complete
ITK1X
PRINTER QUICK SET-UP GUIDE
your specific tickets and/or application
Rev C (5-29-2020)
Advertisement
Table of Contents
Related Manuals for Practical Automation ITK1X
Summary of Contents for Practical Automation ITK1X
- Page 1 ITK1X PRINTER QUICK SET-UP GUIDE When you first set up your printer, follow these simple steps to properly configure your printer to your specific tickets and/or application FOR USING A TICKET WITH BLACK MARK/HOLE Measure target Ticket Length (C), and distance from cut line to Top of Mark (D) in millimeters (mm) ...
- Page 2 FOR USING A TICKET WITH BLACK MARK/HOLE (cont.) Select “Driver Printer Settings “ tab Set “Cut Option” to “Full Cut (Black Mark, Hole)” Confirm that “Backup Before Print” under “FOR CONTINUOUS PRINTING ONLY” section is set to “0” for Black Mark ...
- Page 3 ITK1X PRINTER QUICK SET-UP GUIDE When you first set up your printer, follow these simple steps to properly configure your printer to your specific tickets and/or application FOR USING CONTINUOUS ROLL PAPER Find the ITK12 driver icon (different paths depending on version of Windows), and open the PA ITK12G Properties driver utility ...
- Page 4 ITK1X PRINTER QUICK SET-UP GUIDE If your printer is equipped with a presenter, please follow the following instructions after setting your printer to either Black Mark or Continuous FOR USING A PRINTER WITH A PRESENTER Select “Stored Printer Settings” tab in driver ...
Need help?
Do you have a question about the ITK1X and is the answer not in the manual?
Questions and answers