Hover-1 MY FIRST E-BIKE Operation Manual page 9

ASSEMBLY ASSEMBLY
1. Loosen the outer lug nuts on each side of the
A
front tire. Move the washers and outer lug nuts to
the edge of the axle. Do not move the innermost
lug nuts. Insert the front tire into the front fork.
Insert the hooked washers into the front fork
holes and move the rounded washers toward the
wheel. Use a 15 mm wrench to tighten the outer
lug nuts. Attach the black caps to the lug nuts.
2. Place the rubber grommet (indicated in blue)
B
on the steering column of the handlebar
assembly as shown in Figure B. Insert the steering
column into the front fork. Insert the seat pole
into the frame and clamp the pole at the desired
seat height.
3. Use the multi-tool's hex key to loosen the screw
C
inside the steering column and raise or lower the
handlebars. Tighten the screw at the desired
handlebar height. Tighten the other 2 screws at
the top of the steering column with the hex key if
needed.
4. Line up the protective cover (indicated
D
in blue) with the center of the handlebar assembly
and attach it irmly. Push the centerpiece plate
(indicated in gray) into the protective cover until it
is locked irmly in place.
7