Electrolux SG235NCN User Manual page 59

Problem
Water flows on the floor.
Temperature cannot be
set.
DEMO appears on the
display.
The temperature in the
appliance is too low/too
high.
Side panels of the appli‐
ance are warm.
Door does not open easi‐
ly.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
7.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Possible cause
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FROSTMATIC or
COOLMATIC function is
switched on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
The food products tem‐
perature is too high.
The FROSTMATIC func‐
tion is switched on.
This is a normal state
caused by operation of
the heat exchanger.
You attempted to re-open
the door immediately after
closing.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
ENGLISH
Solution
Attach the melting water out‐
let to the evaporative tray.
Switch off FROSTMATIC or
COOLMATIC manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "FROST‐
MATIC or COOLMATIC
function".
Keep the OK pressed for ap‐
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera‐
ture.
Let the food products tem‐
perature decrease to room
temperature before storage.
Refer to "FROSTMATIC
function".
Make sure that there is at
least 30 mm of space be‐
tween each side of the appli‐
ance and the surrounding
furniture when the ambient
temperature exceeds 38°C.
Wait a few seconds between
closing and re-opening of the
door.
59