Source Setup - NAD S170i Owner's Manual

SOURCE SETUP

The S170i is equipped with nine total inputs: six audio-video inputs (labeled on the rear panel VIDEO1-6),
and 3 audio-only inputs (labeled CD, AUX, and TUNER). There is also an audio-only TAPE MONITOR loop.
For each input position of the S170i, you may select a digital input to become active whenever that input
is selected, and you may assign a 7-character name which will be displayed on the front-panel display and
momentarily on the on-screen display whenever that input is selected.
CONFIGURING SOURCES
From the OSD Main menu, select the <Source setup> menu item using the remote's [Cursor
[Enter] keys. Using the [Cursor
numbered 1-9, which correspond in order to VIDEO1-6, CD, AUX, and TUNER on the rear panel (the TAPE
MONITOR loop is not configurable, and will not appear in the rotation). Use the [Cursor] (down) key to
move to the <Title> menu item, and press the [Enter] key. You may now edit the default title ("Video 1",
"CD," etc.) to a more meaningful name, up to 7 characters. The [Cursor up/down] keys scroll through
the complete list of available characters, while the [Cursor
characters (you may back up and change characters freely). When you are finished with the title, press
[Enter] to return to the <Source setup> menu
Using the [Cursor] (down) key scroll down to the <Digital input> menu item. Use the [Cursor
to assign a digital input to the current source. The digital inputs will appear in order: Coax1-4, OPT 1, and
Opt 2, followed by Off. You would set a source's <Digital input> to "Off" if you wished to ensure that
that source would not play an incoming digital bitstream.
NOTE
You may freely assign any digital input to any source position, and you may assign a digital input to
two or more source positions. For example, with your DVD/CD player connected to the COAX1 digital
input, you might choose to assign COAX1 to both the "CD" and "VIDEO1" inputs, renaming VIDEO1
to "DVD."
The following characters are available:
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 0 1 2 3 4 5 6 7 8 9
a b c d e f g h i j k l m n o p q r s t u v w x y z * - . / :
Using the [Cursor] (down) key scroll down to the <Component video> menu item. Use the [Cursor
keys to set Component video to "On" or "Off." When a source is set to Component video "On," the video
signal present at the S170i's COMPONENT VIDEO IN (Y-Cb-Cr) jacks will be sent to its COMPONENT VIDEO
OUT jacks whenever that input is selected.
• OSDs do not appear on the component-video output.
] keys, call up the source you wish to configure. Sources are
] keys move left and right across the six
CONFIGURING THE S170i
], and
] keys
]
19